50MHz Frequency Counter with IF Offset

50MHz Frequency Counter Module with programmable IF Offset.

Fully built and calibrated (not a kit)

This module is a highly flexible frequency counter that incorporates programmable IF offset (parameters are stored in nonvolatile EEPROM). Its small size allows it to be incorporated into your own equipment and your battery will hardly notice its modest current requirement. A input buffer isolates the counter to minimize loading of the signal source. The 16 character back lite LCD display (white text on blue background) is easily viewable over a wide angle in modest lighting conditions. Operation is as simple as connecting power and a signal source.

  • Fully built and calibrated (not a kit)
  • PIC Processor with EEPROM
  • 16 x 2 character high contrast back lite LCD display (white texton blue background)
  • DIP switch programming
  • 15 pre-programmed IF offsets
  • 1 user programmable IF offset
  • Programmable display calculation: Direct, VFO+IF, VFO-IF, IF-VFO
Pre-defined IF Offsets
  • 0.000MHz, 0.450MHz, 0.455MHz, 0.465MHz, 0.470MHz, 1.600MHz, 4.000MHz,
  • 5.500MHz, 6.000MHz, 9.000MHz, 10.700MHz, 16.900MHz, 21.400MHz, 23.050MHz, Reserved
User definable IF Offset
  • Can be programmed to any frequency in range 0-50MHz
  • Dimensions: 80mm x 35mm
  • Power Supply:
  • 7.5-20VDC @ 20mA, typical, reverse polarity protected
  • 7.5-20VDC @ 100mA, typical, for Back Light LED
  • Input Sensitivity:  see manual (adjustable by on board potentiometer)
  • Input Frequency: 0 Hz to >50 MHz
  • Gate Period: 400ms
  • Controls: LCD contrast, Sensitivity, 4 Way DIP Switch, Prog Jumper
  • Inputs: Power, Signal


All specifications subject to change without notice